A wet autumn in parts of the US Midwest has raised the risk of mould, sprouting and purple seed stain in harvested soybeans, and careful drying, cooling and aeration will decide how well those beans keep in storage.
"A lot of the initial quality concerns were the moldy soybeans, the ones that truly did get wet and molded within the pod," said Matthew Vandehaar, a field agronomist with Pioneer. Some sprouting on upper pods and some purple seed stain were also seen, but mould was the main worry for storage.
The first step is cleaning. Running beans through pre-storage screeners removes split beans and the pockets of moisture and foreign material where moulds and fungi survive.
Damaged beans need quick action. Where sprouting, mould or deep purple discoloration was found, soybeans should be dried quickly to 13% moisture to stop the fungi working, and those lots should go to the elevator first. Beans intended for long-term storage can be dried carefully to 11-12%, though lower moisture raises the risk of splitting. Growers should also allow for moisture lost every time the beans are moved.
After drying, bins should be cooled to 35-40°F (about 2-4°C) as soon as the weather allows, keeping the grain within about 10-15°F of the outside air and at an even temperature through the bin. As outside air cools, cold air at the walls sinks and pushes warm, moist air up the centre, where it condenses. Aeration evens out the temperature and prevents those wet pockets. Because outside air can either dry or rewet the beans, temperature and humidity should be checked before the fans run, using an equilibrium moisture table or calculator.
Once the winter storage temperature is reached, beans should be checked every two weeks for moisture or crusting; running the fans for 15-30 seconds can reveal a musty smell. Fan intakes should be covered when not in use, and bins checked for snow after storms. Temperature and CO2 monitors give extra warning.
Safety comes first if anyone enters a bin: power, fans and unloading equipment must be shut down and locked out, someone must stay nearby, and respiratory protection is needed around mouldy grain. In spring, grain kept longer should be warmed in steps of 5°F or less, to about 45°F for late spring and summer, by running fans on cool, dry nights.
The advice was supplied to CropLife by Pioneer.
Photo: Don O'Brien / Wikimedia Commons (CC BY 2.0)
Source: CropLife





Comments
(0)